Waterproof cranes in ports, marine yards, and outdoor plants need stable crane and trolley positioning under rain, salt spray, dust, and high humidity. Key technical parameters should match the environment and control accuracy. Typical protection is IP65 for general weatherproof duty and IP66 for washdown or heavy splash areas. The positioning system usually combines sealed absolute multi-turn encoders, laser distance sensors, and PLC logic to reach +/-5 mm crane positioning accuracy and +/-3 mm trolley repeatability. Long travel speed is 0 to 30 m/min, trolley speed is 0 to 20 m/min, and hoist speed is set by load. Encoders must be corrosion-resistant, shielded, and rated for outdoor use. The control cabinet uses stainless steel or C5-M anti-corrosion coating, with 380 V/50 Hz main power and 24 V DC control. Operating temperature is -20 to +60 deg C, and humidity tolerance is up to 95% non-condensing. Limit switches, anti-collision sensors, overload protection, and emergency stop are mandatory. Wireless remote control and bus communication improve operation. For precise positioning, use an absolute encoder on the long travel and trolley drive, a laser sensor at the target bay, and a PLC with closed-loop control. Check braking distance against positioning tolerance. Cable reels and festoon systems need UV-resistant waterproof covers. Hoist limits and skew detection should interlock with the travel controller. Regular calibration, cable inspection, and seal checks keep waterproof crane and trolley positioning accurate and safe.

Crane Waterproof Crane and Tro
Overhead Crane High-pressure C
Stacker-reclaimer High-tempera
Bucket Wheel Stacker-reclaimer