Reliable level measurement at sewage treatment gates requires a waterproof radar sensor that tolerates humidity, debris, foam, and corrosive gases. A typical 24 GHz or 80 GHz non-contact radar sensor uses frequency-modulated continuous wave (FMCW) technology to measure water level from 0.2 m to 15 m with +/-3 mm accuracy. The beam angle is usually 6 to 12 degrees, allowing focused measurement in narrow channels and behind gates. The housing is IP68-rated and made of PVDF or PTFE-coated stainless steel for corrosion resistance. Operating temperature ranges from -40 C to +80 C, with pressure up to 1 bar. The sensor supports 24 VDC power, 4-20 mA output, RS485/Modbus, and HART options. It includes surge protection, anti-condensation design, and a sealed cable gland. Optional features include 1.5 kV surge immunity, 0.1% span linearity, a 10 Hz update rate, and Bluetooth or LoRa configuration without opening the cover. The enclosure meets IP68 and NEMA 6P for temporary immersion and washdown. Installation should avoid direct sludge impact; mount the sensor above the gate with a clear view of the water surface. For sewage plants, the sensor should provide stable readings despite floating debris and foam, with a response time under 1 s and repeatability of +/-1 mm. Regular cleaning and calibration ensure long-term accuracy. These parameters make the radar sensor suitable for pump stations, grit chambers, aeration tanks, and gate control in municipal and industrial wastewater treatment.

Material Tank Explosion-proof
Shield Tunneling Radar Sensor
Mixing Station Flange-mounted
Grain and Oil Storage Tank Rad