Corrosion-resistant radar sensors for water conservancy gates apply non-contact microwave measurement to monitor gate opening, water level, and structural position in humid, salty, and chemical-rich environments. The sensor commonly uses frequency-modulated continuous wave (FMCW) radar. A sealed antenna emits a high-frequency microwave signal toward the water surface or gate target. The echo returns with a time delay and frequency difference. Inside the sensor, the received signal is mixed with the transmitted signal to produce a beat frequency proportional to the measured distance. A signal processor performs fast Fourier transform, clutter suppression, and temperature compensation, then converts the result into distance, level, or gate opening values. For a target at distance d, the beat frequency is proportional to d, so calibration and dielectric compensation improve accuracy. The non-contact method avoids abrasion, clogging, and electrochemical corrosion caused by direct contact with water and silt. The corrosion-resistant design is essential: a PTFE or PVDF radome protects the antenna, while a stainless-steel housing and sealed cable glands isolate the circuit from spray, silt, and corrosive gases. The sensor outputs 4-20 mA, RS485, or Modbus data to the control room. It supports remote control. This working principle enables continuous, low-maintenance monitoring, early warning of abnormal gate movement, and reliable operation in sluices, floodgates, and irrigation projects.

Chemical Storage Tank Explosio
Shield Tunneling Storage Tank
Mixing Station Material Tank R
Grain and Oil Storage Tank Fla